SimpleComTools COM1000 Betriebsanweisung PDF herunterladen (Seite 67)

Raven CDMA User Guide for Verizon, version 2.23 61

Basic Commands

These commands are common to most communication devices using AT Com-

mands.

TABLE 3. Basic Commands (common AT commands)

Command Parameters Details

+++

The "+" is ASCII 0x2B.

none AT Escape sequence.

Not proceeded by AT.

If the Raven is in a data mode (any mode other than

PassThru), this command causes the modem to re-enter

AT command mode.

There must be an idle time (set by S50) on the serial port

before and after this command.

The detection of +++ is disabled if DAE=1.

A/ none Re-execute last command.

Not proceeded by AT.

A none Answer - manual

DAE=n n=0 or 1 Disable AT Escape Sequence detection.

0 : Enable +++ AT escape sequence detection.

1 : Disable +++ AT escape sequence detection.

En n=0 or 1 Toggle AT command echo mode.

0 : Echo Off

1 : Echo On

Hn n=1 Hang-Up Command.

1: Hang-up

Note: With an AT telnet connection, this command will

terminate the host data mode and return the Raven to an

AT mode.

O none Online (Remote): Causes the Raven to go from Com-

mand State to data state.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 114 115

Keine Kommentare

SimpleComTools COM1000 Betriebsanweisung Seite 67